This post was last edited by loveyanyu at 2016-4-1821: 48

Mainly because Fengshang MAX, Card 1 supports Nanosim, Card two supports NanoSIM card or SD card, numerous good friends really feel that if they need to use a memory card, they could only place one SIM card, so it is impossible to work with dual SIM cards, that is a bit of a loss really feel. So is there a superb solution to use dual SIM cards and memory cards in the identical time, actually, this system is there, many individuals have written ahead of, by means of DIY can make the memory card and SIM card share a card slot, Even though there are many tutorials online, now I'd prefer to share this approach with you cautiously. The measures are as follows:

The first step: prepare tool scissors, 502 glue, knife, MICROSIM card, or nanosim card, memory card;
Step 2: Prepare the SIM card, micro card or Nano card to be made use of! First cut off free hard drive data recovery software about the micro card or Nano card with scissors to reduce only the chip component, then use the blade to gently pry off the chip. When prying off, use the blade to force in diverse directions. http://www.google.com is also glued to the plastic, recall that brute force shouldn't be utilized, so as not to pry the circuit around the chip. Take a photo before prying the chip to don't forget the path on the chip, so as not to set up the incorrect chip path behind;


Step three: Scrape off the bottom from the chip exactly where the plastic component is lifted gently having a blade, due to the fact the bottom in the chip is protected and raised, in an effort to steer clear of the back into the card slot, so Need to scrape off many of the raised parts;

Step 4: Examine the SI | M card chip with the SD card. If there is certainly no size difference, you'll be able to directly stick for the SD card. If there is a difference, make use of the ready scissors to reduce the same size on each sides of your card. Place it around the opposite side of Cato and make a gesture to find out if there is any gap on each sides. Don't reduce an excessive amount of, or the contacts are going to be broken!

The fifth part is always to stick the SIM card chip with 502 on the side from the TF card out point. The distance above the edge is about 1MM away from the gold finger! You may put the SD card inside the card slot for comparison. Following the comparison, paste it with 502. The chip desires to become stuck in the middle in the left and right of your SD card (verify the path with the SIM card chip among the phones before sticking, and paste it) At that time, do n’t get glue to the position from the gold finger with the SD card and the point in the sim card chip, otherwise it will lead to the inability to call or the memory card to become unusable);

Within the last step, place the sd card and Nanosim card together in the card slot and install it within the phone. Remember, for those who ca n’t install it, do n’t use brute force, shake the card slot, and gradually set up the card slot in to the phone. Otherwise, it's easy to create the SIM card unusable.

See the final effect, dual card + SD card, no longer have to be concerned about becoming unable to work with two SIM cards, or can only use one particular SIM card and a single SD card.

------ For a lot more tutorials, please stay tuned ------